HddStatus 

Almost every EIDE or SATA hard disk includes S.M.A.R.T. data. That information is collected by the drive itself and contains data that the manufacturer considered relevant to check reliability. The data is made up of several attributes that have a current value, a worst one, a threshold, some raw data, and some flags. Basically, when any attribute's current value is below its threshold, the hard disk is considered unreliable and likely to fail. By using several techniques, this report tries to give a wider range of information, basing its analysis on advanced comparisons with normal values based on real hard disks and on expert-like checks. The final results are not to be taken as an absolute truth, but they are almost as good as a professional expert advice about your hard disk status.

Your hard disk is a M4-CT064M4SSD2 with firmware 010G.
Your hard disk is not reporting its temperature.
This is normal for this hard disk model.

		Attribute		Current		Raw
		Raw Read Error Rate		100		000000000000
		Reallocated Sector Count		100		000000000000
		Power On Hours Count		100		000000003853
		Power Cycle Count		100		0000000001C8
		Unknown attribute 170		100		000000000000
		Unknown attribute 171		100		000000000000
		Unknown attribute 172		100		000000000000
		Unknown attribute 173		100		000000000012
		Unknown attribute 174		100		00000000002E
		Unknown attribute 181		100		02A5018C0118
		SATA Downshift Error Count		100		000000000000
		End To End Error Count		100		000000000000
		Reported Uncorrectable Errors		100		000000000000
		Command Time Out		100		000000000000
		High Fly Writes		100		000000000032
		Hardware ECC Recovered		100		000000000000
		Reallocated Event Count		100		000000000000
		Current Pending Sector		100		000000000000
		Offline Uncorrectable Sector Count		100		000000000000
		Ultra DMA CRC Error Rate		100		000000000000
		TA Increase Count		100		000000000000
		Flying Height Measurement		100		000000000000