Hard disk health and reliability analysis

Almost every EIDE or SATA hard disk includes S.M.A.R.T. data. That information is collected by the drive itself and contains data that the manufacturer considered relevant to check reliability. The data is made up of several attributes that have a current value, a worst one, a threshold, some raw data, and some flags. Basically, when any attribute's current value is below its threshold, the hard disk is considered unreliable and likely to fail. By using several techniques, this report tries to give a wider range of information, basing its analysis on advanced comparisons with normal values based on real hard disks and on expert-like checks. The final results are not to be taken as an absolute truth, but they are almost as good as a professional expert advice about your hard disk status.

Your hard disk is a FUJITSU MHZ2160BH G2 with firmware 8909.
The average temperature for this hard disk model is 41°C (min=29°C max=53°C) and yours is 0°C.

  Attribute   Current   Raw
Raw Read Error Rate 100 00000001ED3F
Throughput Performance 100 000001C00000
Spin Up Time 100 000000000000
Start/Stop Count 99 00000000058A
Reallocated Sector Count 100 07D000000000
Seek Error Rate 100 00000000029B
Seek Time Performance 100 000000000000
Power On Hours Count 84 00000000201F
Spin Retry Count 100 000000000000
Calibration Retry Count 253 000000000000
Power Cycle Count 100 00000000053D
Unknown attribute 182 100 000000000000
End To End Error Count 253 000000000000
Head Stability 253 000000000000
Induced Op-Vibration Detection 253 000000000000
Reported Uncorrectable Errors 100 000100000000
Command Time Out 100 00AA00AA00B3
High Fly Writes 100 000000000000
GSense Error Rate 253 000000FD0000
Power Off Retract Count 100 0000002B002B
Load Cycle Count 97 000000010B52
Hardware ECC Recovered 100 000000000083
Reallocated Event Count 100 00001B790000
Current Pending Sector 100 000000000000
Offline Uncorrectable Sector Count 100 000000000000
Ultra DMA CRC Error Rate 200 000000000000
Write Error Rate 100 000000005FB5
Run Out Cancel 100 0064043300E3
Write head 200 000000000000

All the attributes of your hard disk are above the S.M.A.R.T. thresholds set by the manufacturer. This is good.

The overall fitness for this drive is 100%.
The overall performance for this drive is 100%.

The link to get back and see a new report about this hard disk in the future is this. Consider that new hard disks and new checks are added over time.


DISCLAIMER: this report does its best to highlight issues and warnings related to your hard disk. It cannot be held responsible for any mistake. This page and its results cannot be used in any other way but the one defined by its author.