HddStatus 

Almost every EIDE or SATA hard disk includes S.M.A.R.T. data. That information is collected by the drive itself and contains data that the manufacturer considered relevant to check reliability. The data is made up of several attributes that have a current value, a worst one, a threshold, some raw data, and some flags. Basically, when any attribute's current value is below its threshold, the hard disk is considered unreliable and likely to fail. By using several techniques, this report tries to give a wider range of information, basing its analysis on advanced comparisons with normal values based on real hard disks and on expert-like checks. The final results are not to be taken as an absolute truth, but they are almost as good as a professional expert advice about your hard disk status.

Your hard disk is a SAMSUNG HD501LJ with firmware CR100-10.
The average temperature for this hard disk model is 32°C (min=22°C max=42°C) and yours is 24°C.

		Attribute		Current		Raw
		Raw Read Error Rate		100		000000000000
		Spin Up Time		100		000000001C40
		Start/Stop Count		100		0000000000B6
		Reallocated Sector Count		253		000000000000
		Seek Error Rate		253		000000000000
		Seek Time Performance		253		000000000000
		Power On Hours Count		100		000000000EAA
		Spin Retry Count		253		000000000000
		Calibration Retry Count		253		000000000000
		Power Cycle Count		100		00000000006C
		Reported Uncorrectable Errors		253		000000000000
		Command Time Out		253		000000000000
		Hardware ECC Recovered		100		000003DF2EAD
		Reallocated Event Count		253		000000000000
		Current Pending Sector		253		000000000000
		Offline Uncorrectable Sector Count		253		000000000000
		Ultra DMA CRC Error Rate		200		000000000000
		Write Error Rate		100		000000000000
		Soft Read Error Rate		100		000000000000
		TA Increase Count		253		000000000000