HddStatus 

Almost every EIDE or SATA hard disk includes S.M.A.R.T. data. That information is collected by the drive itself and contains data that the manufacturer considered relevant to check reliability. The data is made up of several attributes that have a current value, a worst one, a threshold, some raw data, and some flags. Basically, when any attribute's current value is below its threshold, the hard disk is considered unreliable and likely to fail. By using several techniques, this report tries to give a wider range of information, basing its analysis on advanced comparisons with normal values based on real hard disks and on expert-like checks. The final results are not to be taken as an absolute truth, but they are almost as good as a professional expert advice about your hard disk status.

Your hard disk is a TOSHIBA MK2035GSS with firmware DK022A.
The average temperature for this hard disk model is 40°C (min=27°C max=52°C) and yours is 27°C.

		Attribute		Current		Raw
		Raw Read Error Rate		100		000000000000
		Throughput Performance		100		000000000000
		Spin Up Time		100		00000000042B
		Start/Stop Count		100		00000000017C
		Reallocated Sector Count		100		000000000000
		Seek Error Rate		100		000000000000
		Seek Time Performance		100		000000000000
		Power On Hours Count		95		0000000007E8
		Spin Retry Count		107		000000000000
		Power Cycle Count		100		000000000165
		Power Off Retract Count		100		000000000011
		Load Cycle Count		98		0000000066B6
		Reallocated Event Count		100		000000000000
		Current Pending Sector		100		000000000000
		Offline Uncorrectable Sector Count		100		000000000000
		Ultra DMA CRC Error Rate		200		0000000000CF
		Disk Shift		100		0000000000B4
		Loaded Hours		96		0000000006BE
		Load Retry Count		100		000000000000
		Load Friction		100		000000000000
		Load In Time		100		00000000012A
		Write head		100		000000000000