HddStatus 

Almost every EIDE or SATA hard disk includes S.M.A.R.T. data. That information is collected by the drive itself and contains data that the manufacturer considered relevant to check reliability. The data is made up of several attributes that have a current value, a worst one, a threshold, some raw data, and some flags. Basically, when any attribute's current value is below its threshold, the hard disk is considered unreliable and likely to fail. By using several techniques, this report tries to give a wider range of information, basing its analysis on advanced comparisons with normal values based on real hard disks and on expert-like checks. The final results are not to be taken as an absolute truth, but they are almost as good as a professional expert advice about your hard disk status.

Your hard disk is a ST94019A with firmware 3.09.
The average temperature for this hard disk model is 42°C (min=28°C max=53°C) and yours is 49°C.

		Attribute		Current		Raw
		Raw Read Error Rate		57		000008883E41
		Spin Up Time		99		000000000000
		Start/Stop Count		100		00000000003F
		Reallocated Sector Count		100		000000000000
		Seek Error Rate		81		000007CDA66F
		Power On Hours Count		94		000000001503
		Spin Retry Count		100		000000000000
		Power Cycle Count		98		00000000080E
		Power Off Retract Count		100		00000000010C
		Load Cycle Count		26		0000000244D9
		Hardware ECC Recovered		57		000008883E41
		Current Pending Sector		100		000000000000
		Offline Uncorrectable Sector Count		100		000000000000
		Ultra DMA CRC Error Rate		200		000000000000
		Write Error Rate		100		000000000000
		TA Increase Count		100		000000000000