HddStatus 

Almost every EIDE or SATA hard disk includes S.M.A.R.T. data. That information is collected by the drive itself and contains data that the manufacturer considered relevant to check reliability. The data is made up of several attributes that have a current value, a worst one, a threshold, some raw data, and some flags. Basically, when any attribute's current value is below its threshold, the hard disk is considered unreliable and likely to fail. By using several techniques, this report tries to give a wider range of information, basing its analysis on advanced comparisons with normal values based on real hard disks and on expert-like checks. The final results are not to be taken as an absolute truth, but they are almost as good as a professional expert advice about your hard disk status.

Your hard disk is a WDC WD80EMAZ-00WJTA0 with firmware 83.H0A83.
The average temperature for this hard disk model is 35°C (min=22°C max=49°C) and yours is 48°C.

		Attribute		Current		Raw
		Raw Read Error Rate		100		000000000000
		Throughput Performance		129		000000000070
		Spin Up Time		151		000801B301B4
		Start/Stop Count		100		0000000002E4
		Reallocated Sector Count		100		000000000000
		Seek Error Rate		100		000000000000
		Seek Time Performance		128		000000000012
		Power On Hours Count		100		00000000034E
		Spin Retry Count		100		000000000000
		Power Cycle Count		100		0000000002E4
		Unknown attribute 22		100		000000000064
		Power Off Retract Count		100		0000000002EA
		Load Cycle Count		100		0000000002EA
		Reallocated Event Count		100		000000000000
		Current Pending Sector		100		000000000000
		Offline Uncorrectable Sector Count		100		000000000000
		Ultra DMA CRC Error Rate		200		000000000000