HddStatus 

Almost every EIDE or SATA hard disk includes S.M.A.R.T. data. That information is collected by the drive itself and contains data that the manufacturer considered relevant to check reliability. The data is made up of several attributes that have a current value, a worst one, a threshold, some raw data, and some flags. Basically, when any attribute's current value is below its threshold, the hard disk is considered unreliable and likely to fail. By using several techniques, this report tries to give a wider range of information, basing its analysis on advanced comparisons with normal values based on real hard disks and on expert-like checks. The final results are not to be taken as an absolute truth, but they are almost as good as a professional expert advice about your hard disk status.

Your hard disk is a TOSHIBA MK3255GSX with firmware FG011C.
The average temperature for this hard disk model is 38°C (min=26°C max=51°C) and yours is 38°C.

		Attribute		Current		Raw
		Raw Read Error Rate		100		000000000000
		Throughput Performance		100		000000000000
		Spin Up Time		100		000000000671
		Start/Stop Count		100		000000000E23
		Reallocated Sector Count		100		000000000000
		Seek Error Rate		100		000000000000
		Seek Time Performance		100		000000000000
		Power On Hours Count		93		000000000C26
		Spin Retry Count		172		000000000000
		Power Cycle Count		100		000000000C4A
		SATA Downshift Error Count		100		000000000001
		End To End Error Count		100		000000000000
		Head Stability		100		00000000FFFF
		Reported Uncorrectable Errors		100		000000000000
		Command Time Out		100		000000000001
		High Fly Writes		100		000000000000
		GSense Error Rate		100		00000000019B
		Power Off Retract Count		100		0000000A000A
		Load Cycle Count		92		000000014BC7
		Reallocated Event Count		100		000000000000
		Current Pending Sector		100		000000000000
		Ultra DMA CRC Error Rate		200		000000000000