HddStatus 

Almost every EIDE or SATA hard disk includes S.M.A.R.T. data. That information is collected by the drive itself and contains data that the manufacturer considered relevant to check reliability. The data is made up of several attributes that have a current value, a worst one, a threshold, some raw data, and some flags. Basically, when any attribute's current value is below its threshold, the hard disk is considered unreliable and likely to fail. By using several techniques, this report tries to give a wider range of information, basing its analysis on advanced comparisons with normal values based on real hard disks and on expert-like checks. The final results are not to be taken as an absolute truth, but they are almost as good as a professional expert advice about your hard disk status.

Your hard disk is a TOSHIBA DT01ACA200 with firmware MX4OABB0.
The average temperature for this hard disk model is 33°C (min=26°C max=42°C) and yours is 35°C.

		Attribute		Current		Raw
		Raw Read Error Rate		100		000000000000
		Throughput Performance		139		000000000047
		Spin Up Time		128		000501270127
		Start/Stop Count		100		0000000001F0
		Reallocated Sector Count		100		000000000000
		Seek Error Rate		100		000000000000
		Seek Time Performance		124		000000000021
		Power On Hours Count		100		000000000BCC
		Spin Retry Count		100		000000000000
		Power Cycle Count		100		0000000001F0
		Power Off Retract Count		100		0000000001FF
		Load Cycle Count		100		0000000001FF
		Reallocated Event Count		100		000000000000
		Current Pending Sector		100		000000000000
		Offline Uncorrectable Sector Count		100		000000000000
		Ultra DMA CRC Error Rate		200		000000000000